Avaya 1608 IP Phone Cannot find router over distance trunk

[cspectra]

Does anybody know the reason why the IP Phone 1608 cannot establish connection with the IPO 406 Version 2 over a distance. The situation and set-up we have are the following:
- 2 POE switches between 2 buildings connected via a 1800 ft single-mode fiber trunk.
- The main building switch has a link to the IPO 406.
- The 1608 IP Phones work fine in the main building, but cannot find router (IP 406) once moved over to the second building.
- Other Avaya 5610 IP Phones work fine in the second building.

 

[amriddle01]

The 5610 are probably programmed with a different set of parameters, is this a flat network or VLAN'd off/routed in some way?

ACS - IP Office Implement

"What the Crocodile Hat....was that?

 

[Bas1234]

Same network?

Check the gateway ip address on the second switch.

try a traceroute to the outside ip of the gateway, i bet you get a "timeout" on the second hop.

___________________________________________
It works! Now if only I could remember what I did...

Dain Bramaged
___________________________________________

 

[nzschooltech]

What is the subnet you are on? Are all phones on this subnet?

 

[tlpeter]

The phones do have a router ip address that does not match



ACS - Implement IP Office
ACA - Implement IP Telephony -- ACA - Design IP Telephony
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!