Aux ringer to paging per each ext

[wannabenorteltech]

I have a customer who wants the paging system to ring when certain ext/s ring. Example, call goes to AA and customer presses 1 from a Flash for parts which is ext 225. Well the parts manager is out in warehouse grabing parts but he wants to know when his phone is ringing to run back and grab his phone. The same goes for service at ext 226. They both answer each others calls so their doesn't need to be a different ring for each ext, but both people are always away from their desk.

It is an 0x32 4.1 with 8 LS lines and flash 4 VM. The paging system does have a aux input. What port on the 0x32 do I connect to aux ringer on the paging system?

Any help would be great!

 

[mroberts]

The Aux ringer is on the middle amphenol cable off the mics on the yellow/ brown pair. Install the ringer with it's own power there. Then go into programming set the Aux. Ringer to yes for those two extensions.

Terminals&Sets - Show
Show set: ___ - Enter the ext numebr
223:223 - Show
Line access - Next to
Capabilities - Show
Fwd no answer - Next until you see
Aux. Ringer - Set to Yes.

Now whenever this phone rings the ringer will ring. MRoberts
mroberts@americaii.com

http://www.a1teletronics.com

If you find a tip helpful, please mark it as such.