Hi,
I use VT220-OTM 2.0 to make changes to DN's e.g. changing NCOS values. However, i was wandering how I could make the same change to a range of DN's(extensions) without having to go through each DN individually and then changing the NCOS value.
I suppose what I need is a macro type function which enables me to specify a range of numbers and the change required (e.g. NCOS 9).
Does anyone know how i can achieve this using OTM?
Regards
I use VT220-OTM 2.0 to make changes to DN's e.g. changing NCOS values. However, i was wandering how I could make the same change to a range of DN's(extensions) without having to go through each DN individually and then changing the NCOS value.
I suppose what I need is a macro type function which enables me to specify a range of numbers and the change required (e.g. NCOS 9).
Does anyone know how i can achieve this using OTM?
Regards
