surfmore99
Technical User
A fellow employee just cam back from a confernce last week and he was telling me about how he was able to gain access to their Wireless Network. What they did was supply him and everyone else with a 64MB Jump Drive. He then inserted the Jump Drive into his laptop and it ran the Autorun.inf file. Inside of this it setup all of his wirless setting on his laptop (SSID, WEP, etc.) to be able to connunicate with their Wireless Network. So after that he was up and running on the Wireless Network.
I want to be able to inmplete this same feature at our office. So I started looking into it a little. I found the "Wireless Network Setup Wizard" inside of Windows and started from there. I went though the steps and got to the one for "use a USB flash drive" This allows you to create network settings once ans save them to a flash drive. Then you can use the device to add more computers to your network. After saving the files to the Flash Device the Wizard wants you to plug the flash device into all of the computers/access points next. I do not want to do this step becasue I just want to have it saved to the flash device and not add anything just yet. So I Cancel out of that and then UNCHECK remove network settings from my flas drive. It then creats setupSNK.exe and a Autorun.inf file on the flash drive. When I plug the drive into another computer to load up the settings automatically I receive erorr messages.
My question is this how this should be done or is there another better way to do this? If this is the way what am I doing wrong?
Thank you in advance for your help.
I want to be able to inmplete this same feature at our office. So I started looking into it a little. I found the "Wireless Network Setup Wizard" inside of Windows and started from there. I went though the steps and got to the one for "use a USB flash drive" This allows you to create network settings once ans save them to a flash drive. Then you can use the device to add more computers to your network. After saving the files to the Flash Device the Wizard wants you to plug the flash device into all of the computers/access points next. I do not want to do this step becasue I just want to have it saved to the flash device and not add anything just yet. So I Cancel out of that and then UNCHECK remove network settings from my flas drive. It then creats setupSNK.exe and a Autorun.inf file on the flash drive. When I plug the drive into another computer to load up the settings automatically I receive erorr messages.
My question is this how this should be done or is there another better way to do this? If this is the way what am I doing wrong?
Thank you in advance for your help.