Automatic Route Selection / Desired destination string Issues

[EngMajd1982]

Hi to All,,

I Have Installed two PRI Cards on Business Communication Manager CM450, each PRI has its own number.
I would to Configure these Cards to use the same destination code access (eg.., 9)
For Example :

Majdi dials 9 to enter the first PRI Pilot number. ( 5503224)
Mohammad dials 9 to enter the second PRI pilot number. (5503222)

Thanks

 

[johnpoole]

if it was a pbx you could use idc tables. But there is a forum for norstar/bcm you may want to post that question there.

john poole
bellsouth business
columbia,sc

 

[EngMajd1982]

Thanks John ... but can you tell me in details how can i use and configure the idc tables..

thanks a lot ...

 

[johnpoole]

ld 49
new
idc
cust x
dcno x

1000 return
1000 2001 return

then on the route data block

idc yes
day x
nite x

not at work but that will get you there

john poole
bellsouth business
columbia,sc

 

[DocVic]

Uh, Majd, on the top left side of this screen (scroll up), there are little green stars. Next to the little green stars are forums listed. You want to select:

Nortel: Business
Communications Manager
BCM.

That will get you to the right spot for help.

DocVic
Dedicated to Nortel Products till the end.
Need help?

http://www.TSS-CO.com