Automatic RMX REGEN & GENDB during RLC Upgrade/Update

[Omenas]

Hello,
We want to upgrade OpenScape 4000 V7 Duplex to V8 using Automatic RMX REGEN & GENDB.
All the latest HotFixes have been installed before the upgrade:

After RLC transfer and preparation is finished starting REGEN&GENDB. But here's what I get:

Maybe you have ideas on how to fix this problem?

 

[Moriendi]

I'm not sure about the codeword error, it doesn't look good, but something you have definitely done which will not help, is to transfer only V8 R2.22.0 RLC without the R2 hotfixes. Send the hotfixes along with the RLC. They will activate at the same time, and it also means the LW can be activated at the same time as the reload V7 to V8, so there will be less downtime. So in SWT send the HF for the CSTA, PLT, LW, RMX and ADP for V8 R2.

The PLT HF contains fixes for GENDB failures for the upgrade, at the very minimum you must transfer the PLT HF at the same time as the RLC. But you should really send everything.

 

[Omenas]

But what to do now that PLT hf4 is already activated? As I understand it, does not allow reverting to the previous version of PLT.

 

[Moriendi]

You have misunderstood.

PLT HF 4 is for V7 R2.23.

You need to send the hotfixes for V8, at the same time as the V8 R2 software. You send the V8 HF for CSTA, LW, RMX, ADP because it's convenient. You send the V8 HF for PLT because it may solve your problem.

 

[Omenas]

Thank you very much,
PLT HF was that problem. After transferring PLT HF, GENDB successfully did, but failed Major V8 release activation. The reason is "No valid license for SuSE Linux appliance found". SuSE upgrade protection expired in half a year.
Will have to do firstinstall (