Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Automated Input Parameter Error with QC 9.0

Status
Not open for further replies.

comman8

Programmer
Sep 25, 2006
1
US
I am using Quality Center 9.0 and Quicktest Pro 9.0. I have an automated QTP test that I am calling from QC and I have setup the input parameters in QC to pass to QTP for the test under configuration > automated. The QTP action is setup to accept the input parameters. When the test runs I get the following error and have not been able to figure it out:

No test input parameter "the name of my parameter" specified for test set in Quality Center.

Is there another place to define input parameters for a test in QC other than in the configuration screen of the test itself?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top