autoexec - run function on startup without autoexec??

[sparkbyte]

Is there a way to run a module or a function in a class without having to use either a strtup form or the autoexec macro?

Thanks

John Fuhrman

 

[PWise]

What is it that you want to acomplish

 

[TheAceMan1]

How are ya sparkbyte . . .

Be more specific.

See Ya! . . . . . .

Be sure to see faq219-2884 [blue]Worthy Reading![/blue]
Also faq181-2886 [blue]Worthy Reading![/blue]

 

[DrSimon]

I assume that you are content to run a macro, but don't want use autoexec. If that is the case, then look at: How to use command-line switches in Microsoft Access.

 

[randy700]

How about the Open or Load event of the startup form?


Randy

 

[DrSimon]

I don't understand - you were after something that doesn't use the startup form. But if you now want to use it, of course you can run code from the Open or Load event of a form. Please answer PWise's and TheAceman1's questions if you want any more help.

 

[TheAceMan1]

So what happen to [blue]sparkbyte?[/blue]

See Ya! . . . . . .

Be sure to see faq219-2884 [blue]Worthy Reading![/blue]
Also faq181-2886 [blue]Worthy Reading![/blue]

 

[sparkbyte]

Sorry for the delay.. Had something my boss put me on that had me tied up.

As you know, with an ADP, when you launch it it 1st attempts to connect to the "default" DB backend. I was wanting to override this behaviour.

I will check out the link from DrSimon. Don't know why but just didn't think to look at the command line params.



Thanks

John Fuhrman

 

[PWise]

have you seen my reply in your other post
Start ADP WITHOUT attaching to the Backend first.

why are you so afraid of using a autoexec macro or statup form