Hello
I am a little familiar with the command auto secure, but I watched a video on you tube where a guy uses
auto secure no-interact
when I try using that command I get this message. He is also using this command on the same router, I am not sure about the IOS version
MainRouter#auto save no-interact
^
% Invalid input detected at '^' marker.
MainRouter#
Any suggestions what am doing wrong?
Thanks
I am a little familiar with the command auto secure, but I watched a video on you tube where a guy uses
auto secure no-interact
when I try using that command I get this message. He is also using this command on the same router, I am not sure about the IOS version
MainRouter#auto save no-interact
^
% Invalid input detected at '^' marker.
MainRouter#
Any suggestions what am doing wrong?
Thanks