auto correcting the date

[detota3]

Im trying to stop the switch from changing the date on its own. Every time daylight savings arrives, I go into LD 2 to STAD, and a week later it automatically changes again. Perhaps a ghost?

Nick

 

[KCFLHRC]

LD 2 SDST off

 

[jaxuser]

sounds like your auto daylight savings time dates were never updated when they changed them a couple of years ago.
LD 2 tdst and see how it is set.

 

[detota3]

KCFLHRC,

i tried to turn it off completely in LD 2.

.sdst off
and recieved SEC0019

do i have to go to another load to delete or change?

 

[bhassell2000]

do you have element manager?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[KCFLHRC]

Sounds like you have a CoRes system where your call server and signal server is on the same card. This being the case the LD 2 functions are blocked. You have to do it through UCM.

 

[nessman]

Or log in as ADMIN2 to make time changes.

Make sure your DST settings are correct to reflect the new dates. If you have an NTP server on your network, have that take care of time changes for you.

 

[detota3]

unfortunatly im not sure if i have an ADMIN2 log in. Is that a password that you input after you had already logged in? or just a higher level log in?

 

[KCFLHRC]

Is this a CoRes system? If it is then the Admin 2 isn't going to help you anyway.

 

[detota3]

Nope, just a CS1000M

 

[KCFLHRC]

In that case the admin 2 password should get you there.

 

[nessman]

You would log in as ADMIN2 rather than ADMIN1. If you don't have the password, your vendor should.