AUTH codes

[egnalc]

I am writing concerning the AUTH codes I am deleting from an opt 61. As I am writing this I have just completed deleting 2 pages and I am waiting for the data dump to complete. I still have not found an
easier way to delete them without having to do it manually. I have tried using
the ProComm scripts and had trouble writing it. I have also tried deleting
the entire authorization data block and it says it cannot because there are still existing auth codes. Does anyone know any other way to delete them all
at once? I still have 150 more pages to go.

Thanks

 

[jgideon]

We do this all the time, and I don't even use a script. Prepare a text file one line per code, log in to the pbx, get to ld88, out, aut, 0, (spwd if nessary), and at the 'code' prompt, have Procomm transmit a 'raw ascii' file. (set transfer protocol to raw ascii, click on 'upload', choose the file of codes.) I edit the protocol parameters to pause three seconds (or whatever is appropriate for your pbx) between lines for the code prompt to come back. I usually also capture a log file so you can go back and look at any problems. Good luck!