Australia (Primus) PRI 30 Setup

[darylj]

I have no experience with setting up an E1 (PRI 30) service in Australia and I'm in need of some pointers... In the US, I use a TN464 card with an integrated CSU.

The carrier in AU has provided a "Telus NTU-WS 511/00732" device -- I think I need an external CSU to connect this device to my G650 (amp cable to the TN464) -- right?

If anyone has some experience on this and any information about the "add ds1 xxxxxx" screen config, any help would be greatly appreciated!

Thanks!
DJ

 

[snowman50]

I have not set up any myself other than the training course.

But this guy has produced 3 video guides setting up ISDN Pri trunks

Have a look and see it it helps.

http://www.youtube.com/user/PBXHowTos?feature=BF#p/c/F1A876BC876FBB6B

 

[jordy5535]

FOM A SITE IN SYDNEY:
AND YES, WE USE A THE INTEGRATED CSU ON AN MM710BP BOARD
**************************************************************

DS1 CIRCUIT PACK

Location: 001V2 Name: W0E06127
Bit Rate: 2.048 Line Coding: hdb3

Signaling Mode: isdn-pri
Connect: network
TN-C7 Long Timers? n Country Protocol: 1
Interworking Message: PROGress Protocol Version: b
Interface Companding: alaw CRC? n
Idle Code: 11111111
DCP/Analog Bearer Capability: 3.1kHz

T303 Timer(sec): 4


Slip Detection? n Near-end CSU Type: other

Echo Cancellation? n Block Progress Indicator? n

 

[darylj]

Snowman and Jordy, thanks for your replies. I appreciate the help!

Jordy, I'm curious about using Country Protocol 1 with an AU circuit. I tried a similar configuration and I'm still getting alarms and circuit will come up. Are you also using a "Telus NTU" device? If so, what is the make/model of the CSU you are using?

Thanks again for the help!
DJ