Have an Audix MAP100 4.4-5 with 2g drives in bay 0,1,3 system that I am trying to restore from backup tape after a system crash and rebuild. All was going well with the restore until we hit a message that says "WARNING: Tape Driver HA TC 6 LU 0 - Check Condition : A Blank Check condition has been detected "End of Data detected"
INSERT THE CONTINUOUS CARTRIDGE TAPE AND PRESS ENTER
We have no additional tapes to install and so when we just pressed "ENTER" it just repeats the command.
I understand what it is saying per se but have no additional tapes to install and cannot get out of the screen or continue.
Any advice is appreciated
INSERT THE CONTINUOUS CARTRIDGE TAPE AND PRESS ENTER
We have no additional tapes to install and so when we just pressed "ENTER" it just repeats the command.
I understand what it is saying per se but have no additional tapes to install and cannot get out of the screen or continue.
Any advice is appreciated