ATM WAN Simulation using 2 x 2500's

[swhich]

HI,
I am currently in the process of setting up a lab environment for testing of network monitoring software. We currently have 2 Cisco 2500 series routers connected by Serial cables simulating FrameRelay and I was wondering if this can also be done for ATM.
If it is possible, the steps required to set it up would be very much appreciated as I am definately not a Guru on Router configs.

Thanks
Steven

 

[BOJIKA]

it is impossible.

 

[UNIX72]

The 2500's do not support ATM modules. You would need at least a 2600 router I will go for a 3600 better power. I simulate this at home with two 3600 routers going to a ATM lightstream switch. Expensive to simulate!