Hello
I have an issue with trying to transfer calls using a dialer box connected to a serial port on the back of my pc (This is then connected to Ayaya IP office).
From what i have read i should be able to do it using the following commands
'dial
ATDT first_num;
'ring number to transfer to
ATDT!Second_num;
'hang up and compleate transfer
ATH0
The problem is that i can dial the first number and put them on hold and then dial the second number but when i hang up it disconects the secondnumber and leaves the first one hanging without conecting the two. Does anyone know what i'm doing wrong?
Cheers,
Hugh
If knowlege can create problems it is not through ignorance that we will solve them.
Isaac Asimov
I have an issue with trying to transfer calls using a dialer box connected to a serial port on the back of my pc (This is then connected to Ayaya IP office).
From what i have read i should be able to do it using the following commands
'dial
ATDT first_num;
'ring number to transfer to
ATDT!Second_num;
'hang up and compleate transfer
ATH0
The problem is that i can dial the first number and put them on hold and then dial the second number but when i hang up it disconects the secondnumber and leaves the first one hanging without conecting the two. Does anyone know what i'm doing wrong?
Cheers,
Hugh
If knowlege can create problems it is not through ignorance that we will solve them.
Isaac Asimov