ATA2 Settings, Call Park Retrieve, MICS 2.0

[Case14]

I am having issues using a Durafon 1X (EnGenius)analog cordless telephone on a MICS and ATA2.

1st is link timmers, any suggestions using 7 now.
2nd is Call Park does'nt seam to work, is the highest retrieval code on MICS 2.0 not 125?

 

[gforce9]

I'm guessing the problem is in the delay of the signal from a cordless phone. Have you tried a corded phone for feature access?

 

[phoneguy427]

Using 7 what? When a call is answered by a desk set, the park number is displayed on the set. On 2.0 I think if you park a call from the ATA, it goes to park 9 and goes down from there.

When in doubt RTFM (read the friggin manual)

 

[Case14]

phoneguy427:
I found a handbook thank you - when an ATA devise Parks a Call on MICS 2.0 and above, the retrieval code is in fact 125. You have to retrieve a call on a set before it is displayed!

There are different call timer settings that you can set on an ATA. "7" milli sec is the ATA Flash timmer settings that I tried, I guess you never checked it out before.

gforse9: 7mms worked, I just had to set the flash timmer on the EnGenius phone to the same timmer, default was 6mms.

Thanks all