ATA stand alone module for IPO 400 1

[safenestvmem]

Hello, is there a stand along ATA module for using with a door phone or fax for the IPO 400? I am out of analog ports and wanted to add two more. With the Nortel MICS I use to just install a little stand alone ATA mmodule with a seperate power supply and it just used any vacant digital DN port the other port provided dial tone. I have been loong on the web but not sure what to use. Thank you!

 

[IPOLackey]

For an old IP 403/6/12, the right way to do it is to install a phone 8 module, depending on which control unit you're using.

Do you have any spare expansion ports?

 

[safenestvmem]

I can get one. I also have a fox that is needed on an IP Office 500v2. Same situation. I would like to avoid installing a complete seperate 8 port module if I can get a single port analog module. Do you know if Avaya ever produced one like the Nortel MICS ATA single port? Thank you

 

[IPOLackey]

No, there wasn't anything like that to convert a Digi into Analogue.

If it's a 500v2 then you could enable SIP registrar and user a Cisco SPA122 or similar SIP ATA for 1 or 2 Analogue ports. Will require a 3rd Party IP Endpoint license. Really easy to setup.

 

[safenestvmem]

Thank you very much for the help!