danthephoneman
Vendor
Hi everyone,
This is a new problem I have not seen yet
I have a customer with a 400 3.7 (BFT and MSC were replaced about a year ago),recently one of my techs added a 4th ASM8 module to the system on bus 5, their are currently 2 on this bus. the cards work fine, dialtone ok, you can receive and make calls. The strange thing is after doing a change DN the card will only hold its programming for a short amount of time before it reverts back to it's previous state.
Has anyone seen this before?
This is a new problem I have not seen yet
I have a customer with a 400 3.7 (BFT and MSC were replaced about a year ago),recently one of my techs added a 4th ASM8 module to the system on bus 5, their are currently 2 on this bus. the cards work fine, dialtone ok, you can receive and make calls. The strange thing is after doing a change DN the card will only hold its programming for a short amount of time before it reverts back to it's previous state.
Has anyone seen this before?
