ASA Vector editing

[jcp001]

I've recently upgraded from the Definity Site Administration (DSA) R1 software to Avaya Site Administration (ASA)R1.9. I can't seem to figure out how to insert or delete lines in my vectors. In the char mode the only soft-key I get is Edit and in the GEDI mode I do not see the Edit key. With my original software I had and Edit soft-key to use. Anyone usig this version yet?

 

[RTMCKEE]

We use dsa 1.5 and ran into the same problem. Try chaning your terminal type in the properties. I think we have ours set to 4410. In some of the term types the buttons wont show up, 513 i think, its the same when you run the term emulator mode.

Hope this helps
RTMCKEE

 

[Jolagues]

Keep your current settings hit the edit key at command line

insert then line number you want to add

to remove a line hit edit
type delete at command line. José

Please let me know if this was helpful

 

[jcp001]

Thanks José - That worked for me!!