I have a couple of S30122-X7686-M1/ S30122-K7686-M1-5 Luna 2 power supplies that need to be replaced. Can this be done without bringing down the entire shelf. any help would be appreciated. This is on a Ver 2 hiPath 4000.
As far as I know, as long as you have more than one you should be able to hot swap them. If you have only one I would suggest deactivating the shelf normally and then replacing it. I have reduntant power in all my shelves (4000 V7) and have replaced them while the system is running.
Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA
Hi Sal! I remember you quite well ) Even if the power supply is dead and you have more than one, be sure to turn off the black power switch on the front of the individual power supply before removing the old one, or installing the new one.
Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.