Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Arcserve Raid

Status
Not open for further replies.
Sutja

Sutja

Technical User
Joined
Jan 7, 2003
Messages
2
Location
IE
I am relaively new to Arcserve and I am trying to setup a Tape raid 1 configuration using Arcserve 2000 on a Dell PV136T autoloader with two drives. I have installed the autoloader and raid option. Arcserve can see the autoloader and I can run a normal backup. however when I try to configure the raid option and run a backup I get the following message "Please mount any media" does anyone have a step by step guide on how to configure a raid 1 solution in Arcserve 2000
 
Sort by date Sort by votes
Did you get any response to this? I am having the same problem with a PV132T LTO dual-headed autoloader.

Thanks.
 
Upvote 0 Downvote
Its so long ago I can hardly remember, I think I fixed it by doing a long erase on the tapes and then they became available - a quick erase does not work
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

andre41
  • Locked
  • Question Question
Arcserver 2000
Replies
1
Views
77
Smallboy3uk
Smallboy3uk
stonetown
  • Locked
  • Question Question
Installing ARCserve2000 on Active/Active MSCS
Replies
1
Views
133
AndreaGilbreath
AndreaGilbreath

Part and Inventory Search

Sponsor

Back
Top