Arcserve job cycles

[kbrown6915]

Hello all,
I am new to arcserve, I have a backup job that runs great, but when it finishes it starts the job all over again. It never actually says done. It just cycles the same job one after another. This is a single "run now" job. Any ideas?

Thanks

 

[BETuser]

I'm not sure what you mean but try this. Highlight the job and go into "modify". Go to the schedule tab. Check to see how it is scheduled and schedule it the way you want it.

Hope this helps.

 

[davidmichel]

maybe a corrupt job or queue.
try
close the manager
run cstop
rename the ARCserve subdirectory 00000001.qsd
run start
open manager and creat new job