schillingt
IS-IT--Management
I recently installed Arcserve Image Option. It installed correctly and all indications show that it is working. However I am only getting 51 MB/Minute transfer rate. Any ideas.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ARCSERVE Image Option
- Thread starter schillingt
- Start date
- Status
mplsupport
IS-IT--Management
I would look into the SCSI and/or Tape drive to make sure they are installed correctly.. Maybe an IRQ conflict?
BTW, have you had trouble backing up the c: partition (drive0)? for some reason, my drive1 (d
backs up with no problem, but not c:
Thanks
Chad
BTW, have you had trouble backing up the c: partition (drive0)? for some reason, my drive1 (d
backs up with no problem, but not c:Thanks
Chad
- Status
