Hello,
Just installed Arcserve 9 for Netware. The server install
went fine however; the manger either does not connect or if it does it takes a long time and when I go to set up a job the three engines, tape, engine and DB go offline.
1. Connecting to a Novell 6 server.
2. Using a w2k workstation with Novell client 4.83 tried 4.81 also
3. The server name and IP is in the workstation host file and i can ping the server by name.
4. I am running Arcserve 7 on other servers so I know this should not be so hard.
any suggestions?
Jimmy
Just installed Arcserve 9 for Netware. The server install
went fine however; the manger either does not connect or if it does it takes a long time and when I go to set up a job the three engines, tape, engine and DB go offline.
1. Connecting to a Novell 6 server.
2. Using a w2k workstation with Novell client 4.83 tried 4.81 also
3. The server name and IP is in the workstation host file and i can ping the server by name.
4. I am running Arcserve 7 on other servers so I know this should not be so hard.
any suggestions?
Jimmy