iamdigital
Technical User
Hiya,
I'm currently running Arcserve 2000 with W2k sp2.
Tape Hardware is a DELL PowerVault 130T, 28 slots, 4 L7000 tape drives.
I can write to each drive simultaneosly, but can only perform 1 eject at a time, also I'm unable to eject a tape or perform an inventory if a backup is running.
Getting 'Device busy try again later'
Is there a way to configure my drives to stop this?
I'm currently running Arcserve 2000 with W2k sp2.
Tape Hardware is a DELL PowerVault 130T, 28 slots, 4 L7000 tape drives.
I can write to each drive simultaneosly, but can only perform 1 eject at a time, also I'm unable to eject a tape or perform an inventory if a backup is running.
Getting 'Device busy try again later'
Is there a way to configure my drives to stop this?