Arcserve 2000 Agents Slow as a Turtle

[PCES]

Hey Guys,

I recently upgraded from using Arcserve 6.61 Adv edition to Arcserver 2000 Adv edt. I installed the new agents on each of my NT and NW servers that require to be backed up. The servers range in speed(PII-300 the lowest), but they all connect at 100/full on a Cisco Cataylst 5000 switch. After I upgraded, the performance on the agents have been horrible. Getting something around maybe 10-20 megabits a second. Before running on Arcserve 6.61, It would range from 350mb/s to 450 mb/s on a compaq DLT 35/70gb drive. ANy suggestions?

 

[pauldune]

Well....

Have you tried putting your connections to half duplex?
It sounds strange, but i heard a lot about this and it seems to work....


gtx
Paul

 

[Vicente]

Hola tu has llegado a service pack ( 1 y 2 )
luego de realizar los parches tienes que reiniciar los servidores.
Vicente