Hi 2 all!
I have got a problem with ARCserve 11.5 with the Disaster Recovery option installed.
A back-up job is defined a few weeks ago which did run perfectly until I installed the Disaster Recovery option. When a session finishes the word "Crashed" is mentioned about 3 secs in the "Last Result"-column of the "Job Status"-section within ARCserve. After those 3 secs ARCserve wants to start over the backup session which ends up in a crash as well. This goes on and on and the backup job ends up in a loop of crashes and retries. When I un-install the DR-option everything works fine again.
I checked the CA-knowledgebase and googled around but couldn't find anything usefull in order to solve this problem.
Do you have any suggestions?
Any help will be greatly appreciated!
I have got a problem with ARCserve 11.5 with the Disaster Recovery option installed.
A back-up job is defined a few weeks ago which did run perfectly until I installed the Disaster Recovery option. When a session finishes the word "Crashed" is mentioned about 3 secs in the "Last Result"-column of the "Job Status"-section within ARCserve. After those 3 secs ARCserve wants to start over the backup session which ends up in a crash as well. This goes on and on and the backup job ends up in a loop of crashes and retries. When I un-install the DR-option everything works fine again.
I checked the CA-knowledgebase and googled around but couldn't find anything usefull in order to solve this problem.
Do you have any suggestions?
Any help will be greatly appreciated!