APPL_IP_ID: 137 .135 .128 .255 LYR7: DOWN DSBL

[scanjet]

my call pilot was down re booted now it will not come up.I get this error ELAN011 ELAN 16 host IP=137.135.128.255 disabled due to polling timeout

 

[yyrkroon]

not a valid IP address x.x.x.255 for CP

someone have been fooling around in the CP

 

[yyrkroon]

re-run the config wizard and make sure you have a valid ELAN IP address in the CP and reboot it

 

[scanjet]

the ip address has been fine for over a year

 

[tnphoneman]

255 is not a valid address for the last octet. If your subnet mask is 255.255.255.0 your last octet must be between 1 and 254. There is nothing you or I can do to change this. 255 is the broadcast address.

 

[yyrkroon]

Two addresses are reserved on every network, x.x.x.0 and x.x.x.255

Like tnphoneman states, its the broadcast address.

refer to RFC791-Internet Protocol for IP rules.

 

[scanjet]

so i should change it to anything other than .255

 

[scanjet]

MPCXnotif:connect to mas notification service failed sleep 30s

 

[strmwalker]

scanjet...go to ld 117 prt your host prt host.then stat
your host look at the ip addresses to see which one
is for callpilot.the go to ld 137 stat elnk what does it
tell you then do what yykroon told you go to config
wizard look to see what your switch ip address is
then llok at your elan address.

no problems only solutions

strmwalker

 

[scanjet]

ELNK ENABLED
Ethernet (qu unit number 0):
Host: PRIMARY_ENET
Internet address: 137.135.128.253
Broadcast address: 137.135.129.255
Ethernet address: 00:17:d1:9d:f8:9f
Netmask: 0xffff0000 ; Subnetmask: 0xfffffe00
234 packets received; 221 packets sent
0 input errors; 0 output errors
0 collisions

 

[scanjet]

when i call the call pilot from a phone i get this error ERR648 VITN: 00000484 the call pilot appears to be up it says it can take calls but still nothing when i call into it

 

[strmwalker]

scanjet...what does callpilot tell you when you
look at configuration wizard.what country are
you located in.

no problems only solutions

strmwalker

 

[scanjet]

its set up for pacific time

 

[Triton101]

Check the TRANSCEIVER on the PBX and Link lights on the callpilot.

 

[yyrkroon]

Your PBX IP is 137.135.128.253 and the subnet is 255.255.254.0

therefore, you can use any IP address from 137.135.128.1 thru 137.135.128.254 providing its not being used for something else.

Generally .252 is the secondary_enet on the PBX, so don't use that address.

Run the confiugration wizard in CP and make sure the PBX ELAN IP and Subnet Mask is correct in the CP and also assign a valid IP to CP ELAN interface. reboot the CP after you finish the config wizard and you should be in business

 

[scanjet]

replaced the call pilot input same ip's card works fine

 

[Triton101]

scanjet, it's great you got it going but what do you mean when you say "INPUT".

Thanks.