ANI Display Timer on IVS2 CCIS'ed to 2400

[PFD45]

Calls come in on PRI at 2400, CCIS to IVS2 with Dterm Series E Phone.

ANI shows for 6 seconds.

F&S says this duration can be longer or until end of call.

I cannot find that timer . . . any help?

 

[3racefan3]

Check 08>121 should be 0 for name display for the duration of the call.

 

[PFD45]

Thanks racefan, I gave it a try but the inbound caller ID still only remains for 6 seconds.

Just to be clear, these are inbound DID calls that arrive via PRI at the 2400 where the DID station is programmed at the 2000.

 

[3racefan3]

Maybe a version limitation - from the CCIS feature specification manual for the IPS.
The calling party number is flashing while the Multiline Terminal is ringing on its Prime Line. The duration
of display after the call is answered can be selected by system data programming (display for 6 seconds or
continuously). (Series 3300 software enhancement
But here is the programming:
08>255>1
08>379>0
08>537>0
08>538>0
15>95>1
A726>0>0 - assuming your CCH is 0
08>603>0
08>121>0

 

[PFD45]

Thanks again racefan!
I think you're right about the rev level problem.
My IVS2 is Series 2300 so I may just assign a feature key that recalls caller ID.
I'll post what I end up doing.