I've placed a scan of one of my sketches into AI, used live trace, and expanded the result. I'm now trying to clean up the tracing -- connect paths, add missing lines, etc. I'm using the white arrow tool and joining anchor points, then using the handles to adjust the curves in the lines.
All of this is pretty new to me -- I've taken some tutorials a while ago, but never used these particular techniques before. I find that sometimes I wind up with an anchor point which has only one handle instead of two. Is there any way I can restore both handles? (Also, I don't know how I managed to cause the situation with the missing handles. So I'd love some help with understanding that, too.)
All of this is pretty new to me -- I've taken some tutorials a while ago, but never used these particular techniques before. I find that sometimes I wind up with an anchor point which has only one handle instead of two. Is there any way I can restore both handles? (Also, I don't know how I managed to cause the situation with the missing handles. So I'd love some help with understanding that, too.)