Hello,
I have two networked BCMs with a VoIP trunk connection connecting the two. At BCM1 there is an analog trunk used for incoming and outgoing calls that I would like BCM2 to have access to. I could configure a route on BCM2 to allow BCM2 to access the analog line on BCM1 for outgoing calls. However, the problem lies with incoming calls. If someone calls the number that terminates at BCM1 is there a way to have the line ring on BCM2 at the same time? (target lines, hunting, etc.) Is this possible in rls 1.0, 2.0 or 3.0?
I have two networked BCMs with a VoIP trunk connection connecting the two. At BCM1 there is an analog trunk used for incoming and outgoing calls that I would like BCM2 to have access to. I could configure a route on BCM2 to allow BCM2 to access the analog line on BCM1 for outgoing calls. However, the problem lies with incoming calls. If someone calls the number that terminates at BCM1 is there a way to have the line ring on BCM2 at the same time? (target lines, hunting, etc.) Is this possible in rls 1.0, 2.0 or 3.0?
