The analogue line assigned to the ATA will appear on the data TN of the digital phone that the ATA resides. If you print the associated data TN the DN will be provided accordingly.
Below is an example of how the PABX TN should be programmed for an ATA Port. To program you must put in at the CLS prompt TLD FLXA VCE WTA CPTA. The CLS must be entered in the exact order or else you will continue to get error codes.
REQ: PRT
TYPE: TNB
TN 4 31
DATE
PAGE
DES
DES FAX
TN 004 0 00 31
TYPE 3902
CDEN 8D
CUST 0
FDN
TGAR 1
LDN NO
NCOS 6
SGRP 0
RNPG 0
SCI 0
SSU
XLST
SCPW
SFLT NO
CAC_MFC 0
CLS TLD FBD WTA LPR MTD FND HTD TDD HFD GRLD
MWD RMMD SMWD AAD IMD XHD IRD NID OLD VCE DRG1
POD DSX VMD CMSD SLKD CCSD SWD LND CNDD
CFTD SFD MRD DDV CNID CDCA MSID DAPA BFED RCBD
ICDD CDMD LLCN MCTD CLBD AUTU
GPUD DPUD DNDD CFXD ARHD FITD CLTD ASCD
CPFA CPTA ABDD CFHD FICD NAID BUZZ AGRD MOAD
UDI RCC HBTD AHD DDGA NAMA MIND PRSD NRWD NRCD NROD
DRDD EXR0
USRD ULAD RTDD RBDD RBHD PGND OCBD FLXA FTTC DNDY DNO3 MCBN
FDSD NOVD
CPND_LANG ENG
HUNT
PLEV 02
AST
IAPG 0
AACS NO
ITNA NO
DGRP
MLWU_LANG 0
MLNG ENG
DNDR 0
DTMK
KEY 00 SCR 6245 0 MARP
01
02
03
04
05
DATE 9 JUN 2003
I am not sure if I understood the question but I hope this helps?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.