Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Analog Station Module DID port Assignments

Status
Not open for further replies.

TeleJBAG

IS-IT--Management
Jul 16, 2004
2
US
I have a Norstar modular ICS 4.0 with a 8 port analog station module and I'm having a problem re-assigning a DID to one of the ports.

I use a Norstar Fast RAD with the ICS programming tools but have also gone through **config.

The Analog station module is card 9 and the port I want to change is 901. The B1 channel of 901 is assigned to DID 399 (my DID's are 300-399) and I want to change this DID assignment to 301.

If I try to change this under maintenance I cannot it is grayed out in the Fast Rad and the Maintenance in the **config only shows the status.

Help?
 
i did not quite understand your problem ... state it more clearly
here is my best guess at the problem
looks like recd# 301 is already defined ... look in target line 146 and assign that line to the port 901
 
You wouldn't assign a DID under maintenance. either assign the appropriate target line under terminals & sets->line access->line assignment->show line:___ or under Lines->Show Line->Trunk/Line data->primeset:___ (make sure the rec'd number on the target line is the appropriate DID number.)

JerryReeve
Communications Systems Int'l
com-sys.com
 
I got it. The problem was 301 was configured to 146 and 399 was configured to line 244. The port assignment for 901 was assigned to DN 399. All I did was go under



**config and then to system programming and chose change DN. Doing this swapped the port assignment and then I was able to change the line assignments.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top