We just upgraded a 61c to 1000E 5.0 WATV and we are having an issue where a alarm that dials out on a 500 port on the switch to another device is not sending the correct data information. The set was configured like the old switch and worked fine. Is there something in the route I can turn on or off for the data calls?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Analog ports having issues with Alarm CS1000E 5.0 1
- Thread starter coameno
- Start date
- Status
Similar threads
