analog message waiting lamp

[sonomazr2]

I've searched but cannot find the answer for this. I have CLS MWA LPA HTA FNA and the message waiting dn in vm is set to the ext.
What else it there?

 

[cmawbey]

i believe you need a specific card to do this on analog sets

Colin

 

[1brc]

Do you use "analog message waiting" line cards? If so when you leave a message on that ext. do you get the stuttered dial tone? Do you have a maintainence set with "mik" and
"mck" so you can test the light?

 

[sonomazr2]

the phone system has a hundred other 500's, that have lights.
this particular ext did not have vm, and I was asked to put it on.

I tried setting it up like other 500's. Could I disable the dn, and rebuild by copying from another dn that lights work?

I'll have to check into if there is a maintainence set.

 

[1brc]

That's what I would do first. Out the tn of the set that don't work and copy a set that is known to work. You did put a known good set on that tn just to make sure it is not just a bad light didn't you.

 

[sonomazr2]

the outing of the tn and copying of a good one did the trick.

thanks