analog fax/phone on Cisco 2811 gateway is now working

[boyeharpe]

We have set up a 2811 with 2 analog ports, we can not send via the fax and if we try a normal analog telephone, we can not dial out, but we can ring and send fax to the devices, so communication is working inbound but not outbound. We don't see any traffic on the gateway with debugs either only with inbound calls, is there a special standard in Germany we have to be aware of?
here is the config of the 2 pors:
voice-port 0/1/0
no echo-cancel enable
compand-type a-law
no comfort-noise
cptone DE
!
voice-port 0/1/1
no echo-cancel enable
compand-type a-law
no comfort-noise
cptone DE

 

[ptdog]

Looks like you are missing POTS dial-peers to telco, or VOIP dial-peers to other internal endpoints like CCM or VG.

 

[boyeharpe]

This is already configured.

dial-peer voice 1 pots
service mgcpapp
port 0/0/0:15
!
dial-peer voice 10 pots
incoming called-number .
direct-inward-dial
port 0/0/0:15
!
dial-peer voice 11 pots
destination-pattern 0[1-9].........
port 0/0/0:15
forward-digits 10
!
dial-peer voice 15 pots
destination-pattern 0.T
port 0/0/0:15
!
dial-peer voice 16 pots
destination-pattern 0112
port 0/0/0:15
forward-digits 3
!
dial-peer voice 17 pots
destination-pattern 3198
port 0/1/0
!
dial-peer voice 18 pots
destination-pattern 3199
port 0/1/1
!
dial-peer voice 999090 pots
service mgcpapp
port 0/1/0
!
dial-peer voice 999091 pots
service mgcpapp
port 0/1/1

 

[boyeharpe]

PS. it is easy to see how tired I was when I wrote the above title.

analog fax/phone on Cisco 2811 gateway is "now" working

It is ofcause "NOT"