Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Analog CLID

Status
Not open for further replies.
someguy758

someguy758

Technical User
Nov 3, 2005
130
US
I have been looking around the forum to try to find a way to not display the ACOD+member # for incoming CLID from an analog trunk. One suggestion was to add a name for ACOD in LD 95 but had no luck with that. Is this possible?
 
Sort by date Sort by votes
Not sure if you can without turning name & number display for the set. Are having issues with someone using the Access Code to dial out? If so have you tried setting up Trunk Access Restrictions.
 
Upvote 0 Downvote
It would show the name and number but i dont want the number to show at all. Not having a problem with ppl using the ACOD just wanted to know.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Mokpokpo Agbovon
  • Locked
  • Question
Analog Phone Programming
Replies
4
Views
455
Firebird Scrambler
Firebird Scrambler
krtcomm1
  • Locked
  • Question
CLID on tandem calls outbound to PSTN when calls are forwarded externally
Replies
6
Views
386
krtcomm1
krtcomm1
bltodd
  • Locked
  • Question
ERR008 Digital and Analog Calls in Hang up after initial connection. Calls to outside hangup Fax too
Replies
0
Views
249
bltodd
bltodd
motox2
  • Locked
  • Question
Analog trunking CS1000 to IP Office
Replies
2
Views
272
gwebster
gwebster
Ahsan Tariq
  • Locked
  • Question
exut clid not working in CS1ke rel 5.0
Replies
0
Views
165
Ahsan Tariq
Ahsan Tariq

Part and Inventory Search

Sponsor

Back
Top