Always get an extra blank paper during printing

[leepeng]

I had created a report file using Lanscape Orientation and always get an extra blank paper after printing. There is no printing problem if i redesign the report in Portrait Orientation but i can't affort to do that cause i need to present a lot of information in one row.

Below are the setting for my report file:
Print Setup
------------
Orientation : Lanscape
Size : A4 210x297mm
Source : First Available Tray

Page Setup
-----------
Top Margin : 0.17
Left Margin : 0.25
Right Margin : 0.25
Bottom Margin : 0.25
Use Default Margin

The problem only happend after i print that page. It is OK during the Print Preview.

** My printer is loaded witn A4 size papers.

 

[kenhamady]

Do you have the correct and most current print driver?
Is your top margin too small based on the printable area of your printer? Ken Hamady

http://www.kenhamady.com/

On-site custom Crystal Reports Training and Consulting.
Quick Reference Guide to using Crystal in VB.

 

[jjames]

Try hiding/suppressing the report footer section if your not using it.

 

[kenhamady]

If it were the report footer, it should happen in preview also. Ken Hamady

http://www.kenhamady.com/

On-site custom Crystal Reports Training and Consulting.
Quick Reference Guide to using Crystal in VB.

 

[FoxG]

Hi,

You should also check that the detail/group sections have no blank space at the end of them (ie. use the fit section option from design screen. Put the blank space as the start if necessary.

Geoff

 

[thomasyu]

As a general recommendation, set all margin to 0.3" or above. Most printer has non-printable area of 0.2x"