Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Aloha setup to add router
- Thread starter UDGP1
- Start date
AkamaiAloha
MIS
The pariticulars of your system could vary, but about the only precautions I would recommend is to statically define all addresses (as memembers of the same subnet as router, of course)--for the BOH and for all FOH terminals. For us--on the FOH terminals, I usually defined the default gateway as the server IP, and for the BOH I define the default gateway as the router. Not saying you have to do it this way, but we've done it this way with no problems for a while now.
Other suggestions include mapping PCAW to the server (assuming this is used), and standard security procedures. All of this info more or less assumes you'll have the BOH hooked up to the Internet.
The last thing is, if they aren't used IP now, you might want to have the Lanacfg.exe utility handy just in case.
Others may have additional suggestions, but I've never really ran into snags here (that I am aware of, anyway)--not all that tricky.
Other suggestions include mapping PCAW to the server (assuming this is used), and standard security procedures. All of this info more or less assumes you'll have the BOH hooked up to the Internet.
The last thing is, if they aren't used IP now, you might want to have the Lanacfg.exe utility handy just in case.
Others may have additional suggestions, but I've never really ran into snags here (that I am aware of, anyway)--not all that tricky.
- Status