Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Aloha IBM 4610 2CR Issue

Status
Not open for further replies.

Circle9

Technical User
Dec 21, 2006
314
US
We recently obtained a new IBM 4610-2CR receipt printer and would like it to work with Aloha. It is set up under IBM OPOS right now. The Check Health passes and prints a demo receipt from the OPOS software, but I cannot get it to work with Aloha.

I have it set up correctly in Aloha Manager, but when I start the FOH, it keeps printing half of a check that has since been closed. Any suggestions?
 
We use the IBM 4610 TF6 and 1NR. Do you have dip switches or do they have self configuration(aka hold down the Feed key and the printer prints out its configs)? What do you have them emulating in aloha manager. We set it up as a TM-80, with dip switch 3 in the on position. For the 1NR we use a baud rate of 9600 with Epson Emulation(aka via the self configuration) and TM-80 in aloha. I would also get rid of all of your printer logs in data and newdata.
 
Thanks for the response!

The printer has self configuration, and I've set it up as a TM-80 in Aloha Manager. I did try 9600 baud and Epson emulation, but I'll give it a shot again. Thank you!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top