Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Allow site B to dial out of site A via POT's

Status
Not open for further replies.

curlycord

Programmer
Sep 22, 2002
14,188
Toronto, Canada
BCM50's R6 fully patched, MCDN keycode active

I am drawing a blank on allowing site B to call out on site A's POT's lines.

Setup ups are as (can intercom each other fine) via SIP Trunks/Private

Site A

-DN's 2XX Range
-Lines 016-064 Pool A
-Dest code 9 = Route 000, Absorb All
-Route 000 = Pool A, Public(Unknown)
-Public Rec Dig Length 9 = 11
-Private Network Settings = CDP Private ID 1

Site B

-DN's 3XX Range
-SIP Trunk Routes: Destination digit 2 (for station to station intercom)
-SIP Trunk Routes: Destination digit 7 (for Pool A access site A)
-Dest code 71 = Route 002, Absorb All
-Route 000 = BlocA, Private
-Private Network Settings = CDP, Private ID 1

I am thinking to have site B dial 79 (7 to B, 9 out of A via POTS's lines)

Testing
Monitor B shows 7 is buried and 9 is sent and digits failed with fast busy at dialing 7941 (as if to dial 416-XXX-XXXX)
Monitor at site A does not even flinch.

Seems site A does not acknowledge 9 coming in, am I missing something on Site A?
Dest codes act as received digits or not?, I forget.

Or, what is the best setup from scratch.....I have spent days on this but stumped.

Thanks







________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
Getting close, got Monitor Site A to flinch and more digits allowed to dial and with a slow busy.

Site A

-Dest code 7A = Route 000, Absorb 1
-Route 000 = BlocA, Public


Site B

-SIP Trunk Routes: Destination digit 2 (for station to station intercom)
-SIP Trunk Routes: Destination digit 7 (for Pool A access site A)
-Dest code 7 = Route 007, Absorb 0
-Route 007 = BlocA, Public


________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
I have fixed this.

I thought I programmed both sites Voip lines into Remote Packages 0X, seems on Site A it did not take or I programmed something else to Remote Packages 0X

All good now.


________________________________________
small-logo-sig.png


=----(((((((((()----=
Toronto, Canada

Add me to LinkedIN
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top