Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Allow BCM 450 to automatically push configuration to phones

Status
Not open for further replies.

penroy

MIS
Feb 12, 2006
116
JM
I have a BCM 450 and I would like to configure the system so that once a IP phone is connected to the network the configuration is automatically deployed to the set. The phones I have are i1210.
 
set system dhcp for enable ip phones only.
This will send all the info to the phones
 
That is the configuration I current have, but its not working as it should. The phone are configure on VLAN and I have specified the same in the BCM but the phones just say starting dhcp.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top