All inbound calls to a CS1000 hunt group

[peterdonnelly]

Is it possible to have all inbound calls forwarded to a hunt group hosted on a CS1000. The BCM and the CS have h323 trunks set up between them. If this can be done, could someone be so kind as to give me a couple of pointers.

Thank a mill.

Peter

 

[peterdonnelly]

I can get the calls to come into the BCM and to then forward to a DN on the CS1000. I see the call in the BCM monitor. But if I modify the target line to forward to a hunt group on the CS1000 and then make a call, I see the call coming into the BCM monitor and then just disappears.

 

[Rustymutt]

You need to build routes.

 

[peterdonnelly]

Routes are built
Nrs on cs1000 is configured and operational

It works if I redirect the target line to a dn on the cs1000 but it does not work if I redirect the target line to a hunt group pilot dn on the cs1000. When I say it does not work , what happens is if I the number isi dialled the caller can hear ring tone but the destination does ring ( ie hunt group members)

 

[curlycord]

If it works one way then the call is going through ok from the BCM, you changed the PBX programming only therefore sounds like the receiving end?.

Maybe borrow a working DID at PBX location and test with that same Target and HG perhaps.



=----(((((((((()----=
curlycord

http://www.curlycord.com