octavian10
MIS
Here is a stupid question, why is there no Config T option on a brand new Aironet 1300. I starts up OK, I enter Enable OK, it asks for a password I enter Cisco OK, I type Configure Terminal it says Configure is an invalid input. In the list of available commands configure terminal is not there. I think I'm losing my mind, cause I swear I have programmed these before. Thanks for any help.
"I hear and I forget. I see and I remember. I do and I understand."
- Confucius (551 BC - 479)
"I hear and I forget. I see and I remember. I do and I understand."
- Confucius (551 BC - 479)