I have three switches: one 1912 and two 1924s. I need the two 100BaseTX ports to connect to some hubs, so all I have that could run between the switches is the remaining 10BaseT ports. I would like to aggregate multiple connections between each switch. How would I do that on the 1912? 1924? Is it even possible without using the 100BaseTX ports?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Agreggating on Cisco 1900 series switches
- Thread starter ben324
- Start date
