Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Advice Needed plugging CAD stations into back of Phone ports

Status
Not open for further replies.
adscott

adscott

Technical User
Aug 21, 2006
14
US
Have an issue with users CAD stations who are plugged into 4610 phones opening large files over the network. Windows workstations work fine but these users are getting 15 minute wait times to open a file over our gig link. Everyone else works fine. Is there a best parctice or something to not put power users into the phone ports or should it not make a difference being as its 100Mb switched?
 
Sort by date Sort by votes
The built-in switch in the IP phones only supports 100mb. Power users should have an additional netwrok connection run to their workstations.
 
Upvote 0 Downvote
The ports were accidently hard coded on the switch we are changing to auto negotiate. Think it will fix the issue.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Nuttotaz
  • Locked
  • Question
All IP phone stations disconnect and register back automatically after a few minutes
Replies
7
Views
233
avayaguy23
avayaguy23
DTGMI
  • Locked
  • Question
CM8 and SBC CAD-0230
Replies
1
Views
134
jimbojimbo
jimbojimbo
Juan_Moct
  • Locked
  • Question
AVAYA TN793CP PORTS ISSUES 1
Replies
1
Views
119
lopes1211
lopes1211
S
  • Locked
  • Question
After-Hours Phone Line
Replies
4
Views
374
kyle555
kyle555
tweege
  • Locked
  • Question
Incoming caller id number on stations with bridged appearances
Replies
0
Views
158
tweege
tweege

Part and Inventory Search

Sponsor

Back
Top