ADT r3 dims

[KeyTech]

I'm using ADT r3, (for first time in ages!) and I have a question about the dimensions...
If I have a drawing open, and I'm looking at it through 2 view ports, one being the standard model plan view, and the other in a 3D rotated model view,
and I dimension a wall in the plan it comes out fine, just the way I want it. But it doesn't (by default) display in the other viewport when it is rotated, it will however appear if I was to go to the Top (plan) view of that viewport, but as soon as I rotate it again, it goes...

Anyone know how to get it to display in that view?? Is there special dimension that I have to do??
I know the dim will be rotated also, and that the text will be hard to read, but this is ok....

Thanks.... Jay~

My new Tae Kwon Do website is up and running!!

http://www.airport-tkd.com

~KeyTech

 

[tachout]

Have you looked at your layer display proporties. We use different layers to control the visibility in different view ports in ADT2. If this does not help let me know and I will look further into this.