Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Adjusting charts programatically

Status
Not open for further replies.

gav12345

Programmer
Dec 4, 2003
198
GB
Hello,

We've been using Crystal Reports 10 (and Enterprise 10) for a while on a large scale development project. One thing we've had ongoing issues with are charts.

Essentially there have been a few annoying little glitches. An example is that with line charts, you can only format and save the width etc. of the individual lines on the chart at design time. Any changes made on the preview screen are lost even if you save the report. - This means that you are limited to formatting only the first 4 lines on the chart, since only 4 lines appear at design time (BO support have been unable to suggest a solution).

To get to the point, we thought that it might be possible to have more control of issues like this, if we manipulated the chart programatically. - Does anyone know if, using either Crystal 10, XI, or the .NET version, whether you have more control over charts programatically than you might do in the Crystal designer?

Many thanks for any info.

Gavin
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top