Does anyone know of a script someone could run without using SMIT that would prompt for new user id and user name and add user with predefined defaults?
Thanks for the reply. I have run the above script. Set password but when I try to login as the new user I get the following:
.profile[10]: unmask: not found.
.profile[11]: ch: not found.
It then disconnects my session. Any Ideas?
Thanks,
Judy
Log in as another user and check out the .profile for that user via vi. It sounds like your default profile may be the problem here i.e. there are invalid entries.
Best of luck
PSD
IBM Certified Specialist - AIX V4.3 Systems Support
IBM Certified Specialist - AIX V4 HACMP
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.