Adding the Rev Number on Picking Sheets

[jjsnmc1]

Hi Guys,

On the BOM Picking sheets, the components for each bill have a rev number. On the shhet the rev number shows up as an * (Asterik). I would like it to show the actual number of the revision for the sub-assembly.

Is this just an option that can be turned on, or does this need to be done in Crystal?

If so can someone point me to the correct table to use.

Thanks

 

[AndyMc]

jjsnmc1,

The form prints whatever is on the lines of the Bill. If you choose a bill in BOM Maintenance, go to lines, and change the revision to other than "*", that is what will print.

Andy

 

[BigLouie]

Actually "*" is how MAS stores the current revision. So when it shows * it means it is the current revision.